lf-photo.org.uk

I've been using colorneg for my colour negs with great success, thought I'd try it with B+W.
I've downloaded and installed the B+W extension but can't find any decent instructions telling me where to start.
The colorneg site has a good description but no step by step http://www.colorneg.com/sw.html?lang=en

Can someone tell me how to use it?

Thanks
Ed

Hi Ed

Might this be what you are looking for? http://www.colorneg.com/warumcolorneg_sw.html?lang=en

The most important thing is to scan your B&W negs as linear scans in RGB then convert to Greyscale then use Colorneg. Once opened in Colorneg you will be presented with just a few sliders (not the vast array when using colour). I just tend to play with the gamma until it's looking somewhere near then finish it off in PS.

Paul

In the drop down menu I get all the colour options and then 0-100 options, have I loaded the B+W correctly or do you get all the colour ones showing as well?

Which version are you using? I'm still using v.1.02 and this is the window I get

I'll have a go a reinstalling the B/W bit, I don't get that , thanks for the pic.

Hi Paul,

Would you mind sharing how I install the .negpos bit.
I used to think I knew a bit about macs, but not this afternoon....

Hi Ed

Sorry I missed this post.

I don't think there is a separate B&W bit?... it's just the Colorneg Plug in which defaults to the simpler interface when you load a greyscale image. As I mentioned in my earlier post I am on version 1.02... if you've recently downloaded Colorneg you are probably running version 1.04 which might be different... will download the new version and check it out.

Paul