Page 1 of 1
WTB: Jobo paper clip thingy's
Posted: Fri Sep 25, 2009 4:09 pm Etc/GMT-1+01:00
by Dave Dawson
Sorry about the vauge description but I'm not sure what they are called
I'm after two or three clips that slide onto the internal rails in a Jobo drum to hold the paper in place....Some are just like a split tube whilst others have wings on. Either would be good.
Cheers Dave
Re: WTB: Jobo paper clip thingy's
Posted: Thu Oct 15, 2009 7:20 pm Etc/GMT-1+01:00
by Dave Dawson
Still looking
Cheers Dave
Re: WTB: Jobo paper clip thingy's
Posted: Sat Oct 17, 2009 11:46 am Etc/GMT-1+01:00
by Keith Tapscott
Try Firstcall Photographic. If they don`t have them in stock, they might be able to order them for you.
If you are using a print drum to process 8x10 sheet-films, I find the non-winged clip holders easier to use.
http://www.firstcall-photographic.co.uk ... /view-all/
Re: WTB: Jobo paper clip thingy's
Posted: Mon Dec 07, 2009 5:10 pm Etc/GMT-1+01:00
by Dave Dawson
Still required (all avenues failed)
Cheers Dave
Re: WTB: Jobo paper clip thingy's
Posted: Thu Dec 10, 2009 12:18 am Etc/GMT-1+01:00
by numnutz
Try cutting some single core cable (aprox 9.0mm diameter) into a 1½ inch lengths taking out the centre core(s) then cut a slit in the cable with a razor blade or scalpel to fit the rail in the tank. You may have to make the slit slightly wider at the ends to facilitate installation and removal but it worked for me.
Test 'em first
Hope this helps
nn
Re: WTB: Jobo paper clip thingy's
Posted: Thu Dec 10, 2009 4:18 pm Etc/GMT-1+01:00
by Dave Dawson
numnutz wrote:Try cutting some single core cable (aprox 9.0mm diameter) into a 1½ inch lengths taking out the centre core(s) then cut a slit in the cable with a razor blade or scalpel to fit the rail in the tank. You may have to make the slit slightly wider at the ends to facilitate installation and removal but it worked for me.
Test 'em first
Hope this helps
nn
You may be num but your not dumb....Thanks for the tip
Cheers Dave